BEC 8920AC User Manual page 78

Configuring Your Router
67
Wireless 5G(wl0) & 2.4G(wl1) – WPS Configuration Setup
WPS Configuration Setup
WPS (Wi-Fi Protected Setup) feature is a standard protocol created by Wi-Fi Alliance. WPS is used to
exchange the AP setting with Station and configure AP settings. This feature greatly simplifies the
steps needed to create a Wi-Fi network for a residential or an office setting. The commonly known PIN
method is supported to configure WPS.
WPS: Select enable to enable WPS function. Please note that WPS can only be available when
WPA2-PSK or OPEN mode is configured.
Attention:
1) With the WPS enabled, network must use either WPA (stronger security) or WEP OPEN (no
security) wireless authentication method.
2) Here wireless can be configured as Registrar and Enrollee mode respectively. When AP is
configured as Registrar, you should select "Configured" in the WPS AP Mode below.
Default WPS AP Mode is "Configured".
When AP is configured as Enrollee, the WPS AP Mode below should be changed to "Unconfigured".
Follow the following steps.
BEC 8920AC User Manual