Remote Access - BEC 8920AC User Manual

Remote Access

It is to allow remote access to the router to view or configure.
Parameters
Remote Access: Select "Enable" to allow management access from remote side (mostly from
internet). If disabled, no remote access is allowed for any IPs even if you set allowed access IP
address. So, please note that enabling remote access is an essential step before granting remote
access to IPs.
Enable Service: Select to determine which service(s) is (are) allowed for remote access when remote
access is enabled. By default (on condition that remote access is enabled), the web service (HTTP) is
allowed for remote access.
Click Apply button to submit the settings.
Allowed Access IP Address Range
Used to restrict IP address(es) to access to the system web GUI.
Valid: Enable/Disable Allowed Access IP Address Range
IP Version & IP Address Range: Specify the IP address Range, IPv4 and IPv6 address range can be
supported, users can set IPv4 and IPv6 address range individually.
Click Add to add an IP Range to allow remote access.
Example: How to Enable the Remote Access
1. If user wants to grant remote access to IPs, first enable Remote Access.
2. Remote Access enabled:
 Enable Valid for the specific IP(s) in the IP range to allow the specific IP(s) to remote access
the router.
 Disable Valid for all specific IP(s) in the IP range to allow any IP(s) to remote access the router.
 No listing to prohibit remote access to the device.
BEC 8920AC User Manual
Advanced Setup – Management (Remote Access)
Configuring Your Router
185