Security; Ip Filtering Outgoing - BEC 8920AC User Manual

Configuring Your Router
127
Security – IP Filtering Outgoing

Security

IP Filtering Outgoing

IP filtering enables you to configure your router to block specified internal/external users (IP address)
from Internet access, or you can disable specific service requests (Port number) to /from Internet.
The relationship among all filters is "or" operation, which means that the router checks these different
filter rules one by one, starting from the first rule. As long as one of the rules is satisfied, the specified
action will be taken.
Outbound IP Filtering by default is set to forward all outgoing traffic from LAN to go through the router,
but user can set rules to block the specific outgoing traffic.
Note: The maximum number of entries: 32.
Click Add button to enter the exact rule setting page.
Filter Name: A user-defined rule name. User can select simply from the list box for the application for
quick setup.
IP Version: Select the IP Version, IPv4 or IPv6.
Protocol: Set the traffic type (TCP/UDP, TCP, UDP, ICMP) that the rule applies to.
Source IP address: This is the Address-Filter used to allow or block traffic to/from particular IP
address(es) featured in the IP range. If you leave empty, it means any IP address.
Source Port [port or port:port]: The port or port range defines traffic from the port (specific
application) or port in the set port range blocked to go through the router. Default is set port from range
1 – 65535.
Destination IP address: Traffic from LAN with the particular traffic destination address specified in
the IP range is to be blocked from going through the router, similarly set as the Source IP address
above.
Destination Port [port or port: port]: Traffic with the particular set destination port or port in the set
BEC 8920AC User Manual