Setting The Mode Switches - Extreme Networks SSA-G8018-0652 Hardware Installation Manual

•
Switches 1– 6: For Extreme Networks use only.
•
Switch 7: Clear Persistent Data. Changing the position of this switch from the up position to the
down position clears persistent data on the next power-up of the SSA switch. All user-entered
parameters, such as the IP address, system name, and so on, are reset to the factory default settings.
After the system resets, you can either use the factory default settings or reenter your own
parameters.
•
Switch 8: Clear Admin Password. Changing the position of this switch from the up position to the
down position clears the admin password and restores the factory default password on the next
power-up of the system. After the SSA switch resets, you can either use the factory default settings
or reenter your own password.
Note
Do not change the position of Switch 8 unless it is necessary to reset the admin password to
its factory default setting.
Required Tools for Working with the Mode Switches
Use the following tools to adjust the mode switches on your SSA switch:
•
ESD wrist strap
•
Phillips screwdriver capable of extending 6 or more inches into the unit
•
Flashlight (recommended)
Caution
An antistatic wrist strap is required to perform the procedures in this appendix. Use the
antistatic wrist strap to minimize ESD damage to the devices involved.
Precaución: Para llevar a cabo los procedimientos especificados en el apéndice deberá utilizar
una pulsera antiestática. Esta pulsera sirve para minimizar los efectos de las descargas de
electricidad estática.

Setting the Mode Switches

To reset a mode switch on your SSA switch, follow these steps.
1 Power down the SSA switch.
2 Put on the ESD wrist strap and attach it to the ground receptacle on the switch I/O ports side of the
SSA switch.
3 Remove fan module 2 from the SSA switch as described in step
40.
4 Toggle the appropriate switch to the opposite position relative to its current state.
S-Series Stand Alone (SSA) Switch Hardware Installation Guide
Clearing Persistent Storage or Resetting the System Password
1 on page 40 through step 5 on page
50