Fans; Micro-Usb Port; Management; Virtual Switch Bonding - Extreme Networks SSA-G8018-0652 Hardware Installation Manual

Fans

The SSA switch comes with two installed fan modules to cool the system. The direction of the fan
module airflow is reversible. By default airflows from the I/O port side to the power supply side of the
unit. If your SSA switch configuration requires power supply side to I/O port side airflow, see
the Fan Module Airflow
The SSA fan modules are both field replaceable and hot swappable. For information on how to replace
SSA fan modules, see

Micro-USB Port

The micro-USB port is provided for local file transfer.

Management

You can manage the SSA switch either in-band or out-of-band.
In-band remote management is possible using the Extreme Networks' Extreme Management Center
application or the command line interface (CLI) via Telnet.
Out-of-band management is provided through the RJ45 COM (Communication) port on the front panel
using a PC, a VT terminal, or a VT terminal emulator. For more information, see
Switch to the Network

Virtual Switch Bonding

For data center redundancy, you can configure two co-located SSA chassis to operate as a single logical
chassis managed by one IP address. This is known as a virtual switch bonded chassis. We recommend
connecting the chassis to each other by using at least two 10G ports on each SSA chassis.
For details on how to configure virtual switch bonding, see the
Guide.
S-Series Stand Alone (SSA) Switch Hardware Installation Guide
on page 15 for details about how to reverse the fan module airflow.
Replacing the SSA Fan Module
on page 27.
on page 39.
Connecting Your SSA
S-, K-, and 7100 Series Configuration
Introduction
Reversing
10