Extreme Networks SSA-G8018-0652 Hardware Installation Manual page 21

Note
•
The rack mounting ear provides three holes for securing the SSA switch to the rack. Use at
least two screws or fasteners appropriate to your rack on each side when securing the SSA
switch to the rack.
•
We recommend that power supplies be installed after the SSA switch has been secured to
the rack to minimize weight that must be supported when installing rack screws
To secure the SSA switch to the rack, follow these steps:
1 Ensure that the rack mount ears are properly installed based upon the discussion in
Positioning on page 17.
2 Align the rack mount ear holes with the front rack post holes in either a flush
mount (Figure 10
3 Secure the SSA switch to each rack post with at least two screws or fasteners appropriate to the
rack as shown in callout 1 of the appropriate figure
Figure 9: Securing the SSA Switch to the Rack in a Flush Mount Configuration
1 = 4 to 6 screws or fasteners appropriate to the rack
S-Series Stand Alone (SSA) Switch Hardware Installation Guide
on page 22) configuration.
(Figure 9 or Figure 10 on page 22).
Installation
Rack Mount Ear
(Figure 9) or mid-
21