Mounting The Ssa Switch - Extreme Networks SSA-G8018-0652 Hardware Installation Manual

Mounting the SSA Switch

Note
The SSA switch comes with integrated mounting ears that are adequate for most installations.
For slide-in mounting, high vibration, or high shock installations, an optional rack mount kit
(SSA-FB-MOUNTKIT) is available.
To install the SSA switch in a rack using the optional rack mount kit, follow the pre-installation
discussion here – including:
and Reversing the Fan Module Airflow
Mount Rail Kit Installation
You can install a SSA switch on a flat surface or in a rack. For more information about flat surface
installation, see Installing the SSA Switch on a Flat Surface
There are four possible rack mounting configurations as shown in
•
The switch I/O ports side or the power supply side of the device face front.
•
The device is mounted flush with the rack posts or mid-mounted.
Figure 3: SSA Switch Rack Configurations
1 = Flush mounted with the switch I/O ports facing front (cool air side) 4 = Mid-mounting with the power supply
2 = Flush mounted with the power supply facing front (cool air side)
3 = Mid-mounted with the switch I/O ports facing front
S-Series Stand Alone (SSA) Switch Hardware Installation Guide
Power Supply Airflow and Switch Fan Module Airflow
on page 15 – before proceeding to
on page 52.
on page 22.
Optional Rack
Figure 3, based upon whether:
facing front
5 = Airflow direction
Installation
on page 14
13