Extreme Networks SSA-G8018-0652 Hardware Installation Manual page 33

ro Read-Only access
rw Read-Write access
admin Super-user access to all modifiable parameters
The default password for all three accounts is set to blank (null). For information on changing these
default passwords, refer to the
1 Connect a terminal to the local console port as described in
Console on page 30.
The startup screen displays.
login: admin
Password:
SSA
Command Line Interface
Extreme Networks, Inc.
145 Rio Robles
San Jose, CA 95134 USA
Phone: +1 800 998 2408
E-mail: support@extremenetworks.com
WWW: http://www.extremenetworks.com
(c) Copyright Extreme Networks, Inc. 2016
Chassis Serial Number:
Chassis Firmware Revision:
User admin last logged in WED SEP 14 16:12:42 2016
There have been 0 failed login attempts since then
SSA(su)->
2 At the login prompt, enter one of the following default user names:
•
ro for Read-Only access
•
rw for Read-Write access
•
admin for Super User access. (This access level allows read-write access to all modifiable
parameters, including user accounts.)
3 Press Enter.
4 The Password prompt displays. Leave this string blank and press Enter.
The device information and SSA switch prompt appear as shown in step
The SSA switch is now ready to be configured. The CLI commands enable you to initially set up and
perform more involved management configurations.
For information about setting the IP address and configuring Telnet settings for remote access to SSA
switch management, refer to the
S-Series Stand Alone (SSA) Switch Hardware Installation Guide
S-, K-, and 7100 Series Configuration
xxxxxxxxxxxx
xx.xx.xx.xxxxT
S-, K-, and 7100 Series Configuration
Guide.
Connecting to a Local Management
1 on page 33.
Guide.
Installation
33