Extreme Networks SSA-G8018-0652 Hardware Installation Manual page 73

3 Holding the SSA switch with the I/O connectors facing left, slide the bottom side of the SSA chassis
under the lip on the bottom side of the mounting bracket.
See Figure 38.
Note
You must install the SSA chassis in the orientation shown in
facing left, top of the SSA switch facing out. No other orientation of the SSA chassis is
supported.
Figure 38: Installing the SSA in the Mounting Bracket
4 Insert the top side of the SSA chassis in the mounting bracket.
5 Close the gate to hold the SSA chassis in place.
See Figure 39.
Ensure that the plungers lock into place when you close the gate. If the plungers are in the open
locked position, rotate the plungers clockwise until they unlock.
S-Series Stand Alone (SSA) Switch Hardware Installation Guide
Installing the SSA-WALL-MOUNT Kit
Figure 38: I/O connectors
73