Shutting Down The Ssa Switch Using The Offline/Reset Button - Extreme Networks SSA-G8018-0652 Hardware Installation Manual

Shutting Down the SSA Switch Using the OFFLINE/RESET Button

You can shut down your SSA switch using the OFFLINE/RESET button, shown in
which is slightly recessed behind the SSA switch faceplate. There are two procedures for shutting down
an SSA switch:
•
Recommended Shutdown Procedure
•
Last Resort Shutdown Procedure
Figure 20: OFFLINE/RESET Button
1 = OFFLINE/RESET button
Recommended Shutdown Procedure
Before shutting off power to the SSA switch, press or tap on its OFFLINE/RESET button for less than
one second.
The CPU LED changes from solid green to blinking between green and amber, indicating that the SSA
switch is shutting down. At the end of the shutdown routine, the CPU LED changes to a sequence of
67% amber and 33% off, indicating the system is in a halt state. At this time it is safe to restart the SSA
switch.
When you initiate a controlled shutdown with the OFFLINE/RESET button, you have 60 seconds from
the time the CPU LED starts flashing amber/off until the device automatically restarts.
Last Resort Shutdown Procedure
Caution
This method of shutting down an SSA switch is not recommended except as a last resort,
because all processes currently running on the SSA switch will be interrupted, resulting in loss
of frames.
Precaución: No se recomienda utilizar este método para apagar los módulos SSA. Recurra a él
sólo como último recurso, puesto que interrumpe todos los procesos del módulo en
funcionamiento, lo que podrìa resultar pérdidas de frames.
S-Series Stand Alone (SSA) Switch Hardware Installation Guide
on page 42
on page 42 (not recommended)
Troubleshooting
Figure 20 on page 42,
42