Channel Settings - Rigol DS1074B User Manual

RIGOL

Channel Settings

Each channel of DS1000B series digital oscilloscope has an independent operation
menu and it will pop-up after pressing any button among CH1, CH2, CH3, CH4. The
menu to set CH1 is shown in the table below. Press CH1 to enter the following
menus.
Figure 2-1 Table 2-2 Channel menu (Page 1/2)
Menu
Coupling
BW Limit
Probe
Digital Filter
2-4
Settings Comments
AC
Block DC component of the input
Signal.
DC Pass both AC and DC components of
the input signal
GND Disconnect the input signal.
ON Limit the channel's bandwidth to
20MHz to reduce display noise.
OFF Get full bandwidth.
Set up the probe attenuation factor
0.001X
by 1-2-5 to make the vertical scale
readout correct. including:
...
0.001X,0.01X,0.1X,1X,2X,5X,10X,20
1000X
X,50X,100X,200X,500X,1000X
Set up digital filter (See table 2-5).
Go to the next menu page (The
1/2 followings are the same, no more
explanation).
User's Guide for DS1000B series