Pass/Fail - Rigol DS1074B User Manual

Pass/Fail

The Pass/Fail function monitors changes of signals by comparing the input signal
which is within the pre-defined mask. The testing results not only can be displayed
on screen, but also can be alarmed by opening the system sound settings.
Press Utility→Pass/Fail to go to the following menu.
Figure 2-101 Table 2-55 The Pass/Fail menu (Page 1/2)
Menu
Enable Test
Source
Operate
Msg display
Figure 2-102 Table 2-56 The Pass/Fail menu (Page 2/2)
Menu
Output
Stop
on Output
Mask Setting
User's Guide for DS1000B Series
Setting Comments
ON Turn on Pass/Fail test.
OFF Turn off Pass/Fail test.
CH1, CH2, Select Pass/Fail test on CH1, CH2,
CH3, CH4 CH3 or CH4.
(RUN)
Pass/Fail test stopped, press to run.
■
Pass/Fail test running, press to stop.
(STOP)
ON Turn on Pass/Fail information display.
OFF Turn off Pass/Fail information display.
Settings Comments
Fail Output when Fail condition detected.
Output and beep when Fail condition
Fail +
detected.
Pass Output when Pass condition detected.
Output and beep when Pass condition
Pass+
detected.
ON Stop test when output occur.
OFF Continue test when output occur.
Go to mask setting menu.
RIGOL
2-77