Manual Mode - Rigol DS1074B User Manual

RIGOL

Manual Mode

Press Cursor→Mode→Manual to display the manual mode menu.
Figure 2-141 Table 2-85 The Cursors menu
Menu
Mode
Type
Source
Time values of a pair X cursors and time increment can be measured in manual

mode when selecting X type. (Frequency values and its increment of a pair X
cursors can be measured when selecting MATH source.)
Voltage values of a pair Y cursors and time increment can be measured in

manual mode when selecting Y type.
To do manual Cursor Measurements, please do as the following steps:
1. Select the Manual mode for cursor measurement by pressing soft button as:
Cursor→Mode→Manual.
2. Select channel Source for measurements by pressing soft button as:
Cursor→Source→CH1, CH2, CH3, CH4, MATH.
NOTE: While measuring the channel with MATH, the results are valued with "d"
(division) as units.
3. Select the cursors type by pressing soft button as Cursor→Type→ X or Y.
4. Move the cursors to adjust the increment between the cursors:(Details in the
following Table)
2-102
Settings Comments
Adjust
Manual
parameters manually.
Shown as vertical line to measure the
X
time/frequency values.
Shown as horizontal line to measure the
Y
voltage values.
CH1
CH2
CH3 Select the measurement signal source.
CH4
MATH
the cursor to
User's Guide for DS1000B series
measure X/Y