SMC Networks HRSH090-A Operation Manual page 142

HRX-OM-R026
Chapter 5 Display and setting of various functions
50.
Select contact output signal 1 selected alarm from the table below with [▲] key or [▼]
key, and confirm by pressing "SEL".
Set value
to
Contact output signal 2 function Setting and checking
51.
Press the [SEL] key once.
The set screen of contact output signal 2 functions are displayed on the digital display.
PV
SV
52.
Select contact output signal 2 function from the table below with [▲] key or [▼] key, and
confirm by pressing "SEL".
Set value
5.21 Communication function
5-80
Table 5.21-26 List of set value
Explanation
Setting/checking are not available unless the
function setting of digial output 1 is selected
alarm status signal.
Sets selection alarm.
Set range is AL.01 to AL.48.
Table 5.21-27 List of set value
Explanation
Without signal output
Operation status signal output
Remote status signal output
Ready completion (TEMP READY) signal output
Operation stop alarm signal output
Operation continuation alarm signal output
Alarm status signal output
Selected alarm status signal output
Operation start timer setting status signal output
Operation stop timer setting status signal output
Recovery from power failure setting status signal output
Anti-freezing setting status signal output
Contact input signal 1 pass through signal output
Contact input signal 2 pass through signal output
Warming up function setting status output
Signal output during automatic fluid filling
Initial value
(Default setting)
Initial value
(Default setting)

HRSH Series