SMC Networks HRSH090-A Operation Manual page 139

38.
Select contact input signal 2 from the table below with [▲] key or [▼] key, and confirm
by pressing "SEL".
Set value
7：When the setting of the serial protocol is "Simplified communication protocol 2", "Remote
signal" cannot be set.
Contact input signal 2 type Setting and checking
39.
Press the [SEL] key once.
The set screen of contact input signal 2 type is displayed on the digital display.
PV
SV
40.
Select contact input signal 2 type from the table below with [▲] key or [▼] key, and
confirm by pressing "SEL".
Set value
8 Can be set when the setting of contact input signal 2 is "Run/Stop signal input" or "Remote signal"
Contact input signal 2 delay timer of reading Setting and checking
41.
Press the [SEL] key once.
The set screen of contact input signal 2 delay timer of reading is displayed on the
digital display.
PV
SV
HRSH Series
Table 5.21-20 List of set value
Explanation
Without signal input
Run/stop signal input
External switch signal input(N.O. type)
External switch signal input (N.C. type)

7
Remote signal input
Table 5.21-21 List of set value
Explanation
Setting/checking are not available if the
setting of contact input signal 1 is OFF.
Alternate signal
 8
Momentary signal
Chapter 5 Display and setting of various functions
(Default setting)
(Default setting)
HRX-OM-R026
Initial value

Initial value

5.21Communication function
5-77