SMC Networks HRSH090-A Operation Manual page 141

46.
Select contact output signal 1 function from the table below with [▲] key or [▼] key,
and confirm by pressing "SEL".
Set value
Contact output signal 1 operation Setting and checking
47.
Press the [SEL] key once.
The set screen of contact output signal 1 operation is displayed on the digital display.
PV
SV
48.
Select contact output signal 1 operation from the table below with [▲] key or [▼] key,
and confirm by pressing "SEL".
Set value
Contact output signal 1 selected alarm Setting and checking
49.
Press the [SEL] key once.
The set screen of contact output signal 1 selected alarm is displayed on the digital
display.
PV
SV
HRSH Series
Table 5.21-24 List of set value
Explanation
Without signal output
Operation status signal output
Remote status signal output
Ready completion (TEMP READY) signal output
Operation stop alarm signal output
Operation continuation alarm signal output
Alarm status signal output
Selected alarm status signal output
Operation start timer setting status signal output
Operation stop timer setting status signal output
Recovery from power failure setting status signal output
Anti-freezing setting status signal output
Contact input signal 1 pass through signal output
Contact input signal 2 pass through signal output
Warming up function setting status output
Signal output during automatic fluid filling
Table 5.21-25 List of set value
Explanation
N.O type
N.C type
Chapter 5 Display and setting of various functions
(Default setting)
HRX-OM-R026
Initial value
(Default setting)

Initial value

5.21Communication function
5-79