NEC WL1700-MS Installation Manual page 192

Data Assignment
Chapter 4
Configure Access Points
4
Table 8. Configure Access Points - AutoRF is enabled in this case
PARAMETERS
Internal Serial Number
AP (printed on the bottom)
Model
External AP1 to AP3
Serial Number
(printed on the bottom)
Model
158
REMARKS
Input the serial number (indicated as
"S/N") printed on the bottom of WL
Intelligent Access Point [10
alphanumeric characters].
Select a model to be used.
In the case of using APs in Japan,
select WL1700-MS(AP)-JP.
In the case of other than Japan, select
WL1700-MS(AP).
Select this box and specify the
following:
Input the serial number (indicated as
"S/N") printed on the bottom of the
WL Access Point [10 alphanumeric
characters].
Select a model to be used.
In the case of using APs in Japan,
select WL1500-AP-JP. In the case of
other than Japan, select WL1500-AP.
INITIAL SETUP