NEC WL1700-MS Installation Manual page 138

Data Assignment
Chapter 4
After restart has been completed, connect the Controller to your network
43
(LAN/WAN).
The following is an example when PC is connected to SCA-WL10. WL5100
is connected through Ether 1 connector.
The following is an example when connecting WL1700-MS to LAN/WAN.
Connect the LAN cable to Ether connector of WL1700-MS.
Connect a LAN cable to the Ether Connector.
104
Basic Settings
Front
PWR ALM ACT LOAD
Connect the LAN cable to Ether1 Connector.
LAN/WAN
Network Equipment (SW HUB,etc)
Rear
PoE HUB
INITIAL SETUP
100M LINK 100M LINK
Ether1 Ether2
10BASE-T/100BASE-TX
Maintenance Console
10BASE-T/100BASE-TX
PoE Feeding Adaptor/
PoE HUB
Setup PC