NEC WL1700-MS Installation Manual page 187

Table 6. Configure Mobility Domain, when multiple controllers (such
as WL1700-MS) are used.
PARAMETERS
This controller will act as
Domain Name
Seed IP Addresses
Member IP Addresses #1– #5
After you finished data assignment, click the Next> button to move to Step3-4
screen. If an input error is in the existing screen, an instruction message will be
displayed indicating which parameter input is wrong.
REMARKS
Assign a role (seed or member) to
a Controller. By default, None is
assigned.
– None: Assigned when mobility
– Seed: Assigned as seed
– Member: Assigned as member.
Specify a Mobility Domain name
[A maximum of 32 alphanumeric
characters, no space]. This
parameter becomes available to
input when seed is selected in
This controller will act as. If no
character is assigned, default will
be applied.
Assign an IP address for
seed-functioned Controller. This
parameter becomes available to
input when member is selected in
This controller will act as.
Assign IP addresses for all of the
members in the Mobility Domain.
This parameter becomes available
to input when seed is selected in
This controller will act as.
INITIAL SETUP
Data Assignment
Chapter 4
domain is not created.
153