NEC WL1700-MS Installation Manual page 127

Assign RF Security.
23
Profile for ESSID (B1)
a
The following is an example when 802.1X is set to Service Profile
(Dot1x-B) in ESSID (B1)
WL111111#set service-profile
Profile for ESSID (B2)
b
The following is an example when WPA (TKIP) is set to Service Profile
(WPA-B) in ESSID (B2)
WL111111#set service-profile
WL111111#set service-profile
Profile for ESSID (A1)
c
The following is an example when WPA (TKIP) is set to Service Profile
(WPA-A) in ESSID (A1).
WL111111#set service-profile
WL111111#set service-profile
Data assignment for each security are as follows. Note that the following data
assignment is required at default setting. If you have already changed the
settings, check all the parameters by seeing
Modes," on page
Security
802.1X set service-profile {Service Profile Name} attr vlan-name {VLAN name}
set authentication dot1x ssid {ESSID} {user name} pass-through {Server Group name}
WPA (TKIP) set service-profile {Service Profile Name} wpa-ie enable
set service-profile {Service Profile Name} attr vlan-name {VLAN name}
set authentication dot1x ssid {ESSID} {user name} pass-through {Server Group name}
WPA2 (TKIP) set service-profile {Service Profile Name} rsn-ie enable
set service-profile {Service Profile Name} attr vlan-name {VLAN name}
set authentication dot1x ssid {ESSID} {user name} pass-through {Server Group name}
WPA2 (CCMP) set service-profile {Service Profile Name} rsn-ie enable
set service-profile {Service Profile Name} cipher-tkip disable
set service-profile {Service Profile Name} cipher-ccmp enable
set service-profile {Service Profile Name} attr vlan-name {VLAN name}
set authentication dot1x ssid {ESSID} {user name} pass-through {Server Group name}
Basic Settings
.
Dot1x-B attr vlan-name
.
WPA-B wpa-ie
WPA-B attr vlan-name
WPA-A wpa-ie
WPA-A attr vlan-name
95.
Required Data Assignment
INITIAL SETUP
Data Assignment
default
enable
default
enable
default
Table 3, "Parameters for Security
Chapter 4
93