NEC WL1700-MS Installation Manual page 150

Data Assignment
Chapter 4
Performing the following steps with
create a WL network. The following is a network configuration when you perform
the basic settings.
Ch=11
Tx=10
AP2
Serial ID=123456789
RF2(802.11a)
ESSID=A1(WPA)
Ch: Channel
Tx: AP Transmission Power
RF: Radio Frequency
ESSID Identifier in wireless networks
Note.
To create the above network, DHCP Server is required to distribute IP
addresses to WL Access Points. If you use Simple DHCP Server function installed in
Controller, refer to step 21 on page 92
For more information about examples of network configurations, refer to the
Appendix on page
116
RADIUS Server
IP Address 192.168.10.100
ESSID=B1(802.11x)
Layer 2 Switch (PoE)
RF1(802.11b/g)
Serial ID=987654321
Ch=6
Ch=36
AP1
Tx=10
Tx=10
RF1(802.11b)
ESSID=B1(802.1X)
ESSID=B2(WPA)
in CLI.
183.
INITIAL SETUP
marks (minimum settings) can
Basic Settings
DHCP Server
100M LINK 100M LINK 100M LINK 100M LINK
PWR ALM ACT LOAD PWR ALM ACT LOAD
Ether1 Ether2 Ether1 Ether2
HTTPS
Maintenance Console
Default Gateway
IP Address 192.168.10.25
Subnet Mask 255.255.255.0
ROUTER xxxx