Overview For Basic Data Assignment Using Cli - NEC WL1700-MS Installation Manual

Data Assignment
Chapter 4

Overview for Basic Data Assignment Using CLI

The following is an overview for basic data assignment using CLI, which is
labelled
Basic Settings
page 83.
Log in to Controller via telnet
Enter Administrative access mode
System Configuration
Controller
Controller
Controller
Create Service Profiles
AP
80
in "Procedures for Data Assignment Using CLI" on
START
Interface Setting
Use Authentication?
(802.1X, WPA,etc)
Yes
Security Settings
NEXT PAGE
INITIAL SETUP
From step 1 on page 83
From step 2 on page 83
From step 3 on page 84
From step 18 on page 90
No
From step 19 on page 91
From step 22 on page 92