NEC WL1700-MS Installation Manual page 179

The following is an example when connecting WL1700-MS to LAN/WAN.
Connect the LAN cable to Ether connector of WL1700-MS.
Connect a LAN cable to the Ether Connector.
Check to see if the Controller is operating normally in your network.
22
Basic Settings
Check the Controller by using ping or tracert command.
Besides, use telnet command to log in to the Controller and use show
command to check the parameters assigned. For more information on those
commands, refer to
When using WL1700-MS
l
After confirming that the Controller is in normal state, attach the WL
Intelligence Access Point to an appropriate location. For more information,
refer to "Access Point Installation" on page
Rear
10BASE-T/100BASE-TX
PoE HUB
Setup PC
"Check Configurations/Network Status" on page
INITIAL SETUP
Data Assignment
PoE Feeding Adaptor/
PoE HUB
58.
Chapter 4
106.
145