About Cli - NEC WL1700-MS Installation Manual

Data Assignment
Chapter 4

About CLI

The two types of the command mode exist in WL Controllers: Network Access
Mode and Administrative Access Mode. When you log in to a Controller, you
automatically enter Network Access Mode. To configure the Controller settings,
type enable to enter Administrative Access Mode.
As a default prompt, "WL + the last six digits of MAC address" is shown.
Explanation of each mode is as follows:
Table 2. CLI Command
Mode
Network Access Mode
Administrative Access
Mode
Note.
When the UNIVERGE WL Controller is in factory default state or after CLI
prompt changing, "*" appears at the head of the prompt until the prompt setting is
saved.
78
Prompt Explanation
> A part of Config File can be displayed
by using show commands.
# Config file can be edited/deleted/
displayed by various commands.
INITIAL SETUP