9.8 Configuring Web Connections
In the Configuration page, select the Video Out tab, then the Data Sources sub-tab. After
that, select an unused data source to configure. To configure a web connection, set Data
Source Type to Web Page.
Type in the address of the web page in Connection URI. Type in a name (optional) for the data
source, check Enabled to enable this data source and press Save at the bottom to save the new
configuration.
Note: The ION-R200 connects to a web page ONLY when that web page is displayed.
Enabling a data source indicates that the ION-R200 can establish this connection
when needed, not that it needs to do so right away. Disabling a data source pre-
vents the ION-R200 from connecting to the web page for any reason.
To display the web page, we need to add it to a view. In the Configuration page, select the
Video Out tab, then the Views & Tiles sub-tab. Scroll down to the Tile Selection section.
For the top right tile, click on the Data Source field and select our newly configured web page
data source. Click on Save at the bottom to apply the change.
ION-R200 – User manual
Page 37 of 49
Need help?
Do you have a question about the ION-R200 and is the answer not in the manual?