Receiving And Storage - WEG CFW-11 User Manual

General Instructions

2.5 RECEIVING AND STORAGE

The CFW-11 frame size E models are supplied packed in wooden boxes.
There is an identification label affixed to the outside of this package, the same one that is affixed to the side
of the inverter.
Follow the instructions below to remove the CFW-11 from the package:
1- Put the shipping container over a flat and stable area with the assistance of another two people.
2
2- Open the wood crate.
3- Remove all the packing material (the cardboard or styrofoam protection) before removing the inverter.
Check the following items once the inverter is delivered:
Verify that the CFW-11 nameplate corresponds to the model number on your purchase order.
Inspect the CFW-11 for external damage during transportation.
Report any damage immediately to the carrier that delivered your CFW-11 inverter.
If CFW-11 is to be stored for some time before use, be sure that it is stored in a clean and dry location that
conforms to the storage temperature specification (between -25 °C and 60 °C (-13 °F and 140 °F)). Cover the
inverter to prevent dust accumulation inside it.
ATTENTION!
Capacitor reforming is required if drives are stored for long periods of time without power. Refer to
the procedures in
2-10 | CFW-11
Section 6.5 PREVENTIVE MAINTENANCE on page 6-9.