Typical Control Connections - WEG CFW-11 User Manual

3.2.6 Typical Control Connections

Control connection 1 - Run/Stop function controlled from the keypad (Local Mode).
With this control connection it is possible to run the inverter in local mode with the factory default settings. This
operation mode is recommended for first-time users, since no additional control connections are required.
For the start-up in this operation mode, please follow instructions listed in
AND START-UP on page
Control connection 2 - 2 - Wire Start/Stop function (Remote Mode).
This wiring example is valid only for the default factory settings and if the inverter is set to remote mode.
With the factory default settings, the selection of the operation mode (local/remote) is performed through the
operator key LOC (local mode is default). Set P0220 = 3 to change the default setting of HMI key
REM
remote mode.
H
≥5 kΩ
AH
Run/Stop
Forward/Reverse
(FWD/REV)
Jog
5-1.
Connector XC1
1 + REF
2 AI1+
3 AI1-
4 - REF
5 AI2+
6 AI2-
7 AO1
8 AGND (24 V)
9 AO2
10 AGND (24 V)
11 DGND *
12 COM
13 24 Vcc
14 COM
15 DI1
16 DI2
17 DI3
18 DI4
19 DI5
20 DI6
21 NF1
DO1
22 C1
(RL1)
23 NA1
24 NF2
DO2
25 C2
(RL2)
26 NA2
27 NF3
DO3
28 C3
(RL3)
29 NA3
Figure 3.24 - XC1 wiring for control connection #2
Installation and Connection
Chapter 5 FIRST TIME POWER-UP
CFW-11 | 3-31
LOC to
REM
3