Setting Basic Application Parameters - WEG CFW-11 User Manual

5.2.3 Setting Basic Application Parameters

After running the Oriented Start-up routine and properly setting the parameters, the inverter is ready to operate
in the V/f mode.
The inverter has a number of other parameters that allow its adaptation to the most different applications. This
manual presents some basic parameters, whose setting is necessary in the majority of cases. To make this task
easier, there is a group named Basic Application. A summary of the parameters inside this group is listed in
5.1 on page 5-6. There is also a group of read only parameters that shows the value of the most important
inverter variables such as voltage, current, etc. The main parameters comprised in this group are listed in
5.2 on page 5-7. For further details, please refer to the CFW-11 programming manual.
Follow steps outlined in
The procedure for start-up in the V/f operation mode is finished after setting these parameters.
Step Action/Result
1 - Monitoring mode
- Press "Menu"
(right soft key)
3 - Group "01
PARAMETER GROUPS" is
then selected
5 - Group "03
CHANGED PARAMETERS" is
selected
7 - Parameter "Acceleration
Time P0100: 20.0 s" has
been already selected
- If needed, set P0100
according to the desired
acceleration time. To do so,
press "Select"
- Proceed similarly until all
parameters of group "04
BASIC APPLICATION" have
been set. When finished,
press "Return" (left soft key)
9 - The display returns to the
Monitoring mode and the
inverter is ready to run
Figure 5.3 on page 5-5 to set the parameters of the Basic Application group.
Display Indication
Ready 0rpm
LOC
0 rpm
0.0 A
0.0 Hz
15:45 Menu
Ready 0rpm
LOC
00 ALL PARAMETERS
01 PARAMETER GROUPS
02 ORIENTED START-UP
03 CHANGED PARAMETERS
Return 15:45 Select
Ready 0rpm
LOC
00 ALL PARAMETERS
01 PARAMETER GROUPS
02 ORIENTED START-UP
03 CHANGED PARAMETERS
Return 15:45 Select
Ready 0rpm
LOC
Acceleration Time
P0100: 20.0s
Deceleration Time
P0101: 20.0s
Return 15:45 Select
Ready 0rpm
LOC
0 rpm
0.0 A
0.0 Hz
15:45 Menu
Figure 5.3 - Setting parameters of the Basic Application group
First Time Power-Up and Start-Up
Step Action/Result
2 - Group "00
ALL PARAMETERS" has been
already selected
4 - Group "02
ORIENTED START-UP" is
then selected
6 - Group "04 BASIC
APPLICATION" is selected
- Press "Select"
8 - Press "Return"
Table
Table
Display Indication
Ready 0rpm
LOC
00 ALL PARAMETERS
01 PARAMETER GROUPS
02 ORIENTED START-UP
03 CHANGED PARAMETERS
Return 15:45 Select
Ready 0rpm
LOC
00 ALL PARAMETERS
01 PARAMETER GROUPS
02 ORIENTED START-UP
03 CHANGED PARAMETERS
Return 15:45 Select
Ready 0rpm
LOC
01 PARAMETER GROUPS
02 ORIENTED START-UP
03 CHANGED PARAMETERS
04 BASIC APPLICATION
Return 15:45 Select
Ready 0rpm
LOC
01 PARAMETER GROUPS
02 ORIENTED START-UP
03 CHANGED PARAMETERS
04 BASIC APPLICATION
Return 15:45 Select
CFW-11 | 5-5
5