4.2.1.3 Power Supply Status LEDs
There are two power supply inlets in the system (for redundancy). The system can operate with
only one power supply connected. In case the power supply is an FRU, a second power supply
unit can be added to support hot-swap ability. Each power supply unit has a single 2 color LED
on the right side of the unit, that indicates the status of the unit.
The primary power supply (PS) unit is located on the left side and the secondary unit is located
on the right side.
Table 16 - Power Supply Unit Status Front LED Assignments
LED Behavior
Solid Green
Solid Red
Off
Figure 27: Power Status LED
Figure 28: Rear Side Panel
Description
All plugged (one or two) power supplies are
running normally.
One or both of the power supplies are not
operational or not powered up/ the AC power
cable is disconnected
N/A
Action Required
N/A
Make sure the AC cable is plugged in
and active. If the problem resumes, the
FRUs might be faulty, and should then
be replaced.
N/A
Mellanox Technologies
Rev 1.2
43