Operator Input Steps In Edit Mode Of The Device Settings - Siemens SENTRON PAC4200 Manual

8.2.5

Operator input steps in edit mode of the device settings

Entering the password
If device protection is switched on, the device demands input of the valid password.
You can find information on password management in the "Password management" chapter.
Change value
Switching options ON/OFF
F4
F4
The setting takes effect immediately. Saving with F4
Selecting from several settings
F2
F3
The last value in the available set of values is followed again by the first value.
Incrementing or decrementing a value
F2
F3
The highest value of the available set of values is followed again by the lowest.
Defining multi-digit values
If F3
an address value.
F3
F2
values is followed again by the lowest.
Saving the value
F4
Canceling editing
F1
See also
Password management (Page 141)
Password protection (Page 49)
SENTRON PAC4200
Manual, 09/2008, A5E02316180B-01
switches a function or status ON/OFF.
switches between several options that cannot be effective at the same time.
scrolls up through the range of selectable settings.
scrolls down through the range of selectable settings.
increases the value in increments of 1.
decreases the value in decrements of 1.
is available, the digits of a value can be changed, e.g. specific address digits of
runs through the digits of the value from left to right.
increments the value at the selected digit. The highest value of the available set of
saves the set value and returns to display mode.
cancels editing and returns to display mode. All changes are discarded.
Operator control
8.2 Operator input steps
no longer applies.
115