Table 3- 6 The Following Events Are Reported - Siemens SENTRON PAC4200 Manual

Description
3.16 Events
Table 3- 6 The following events are reported:
Event
START PMD
PMD INFO
COMM.FAULT
FW UPDATE #
TIME CORR:
TIME SYNC #
VOLTAGE #
VOLTAGE
CURRENT
LIMIT
LIMIT
52
Event Standard
class warning
level
System Information
information
System Warning
information
System Warning
information
System Warning
information
System Information
information
System Information
information
Operating Warning
information
Operating Alarm
information
Operating Alarm
information
Operating Information
information
Operating Information
information
Reason
Voltage recovery
PMD information
A communications fault has
occurred at the slot xx interface.
Transmission error:
The firmware is not suitable.
Top of minute:
The time has been corrected.
The time synchronization has
failed.
Interface: Slot xx
The supply voltage has been
interrupted.
Measured variable x
The voltage is out of range
Measured variable x
The current is out of range.
Measured variable x
The upper limit value xxxx has
been exceeded.
Measured variable x, limit
value xxxx
The lower limit value xxxx has
been exceeded.
Measured variable x, limit
value xxxx
Remedy
-
Please contact Support.
Check the network
settings
Make sure you are using
the correct firmware
version for the update.
Restart the firmware
update.
-
The "Top of minute"
pulses for synchronizing
the time are not active.
Check the hardware and
the settings for
transmitting the "Top of
minute" pulses.
The device has been
disconnected from the
network in accordance
with the schedule.
An error has occurred.
Check the power supply.
Danger of serious or
fatal injury or of serious
damage to the device.
Make sure the system is
operating under
conditions for which
SENTRON PAC is
approved.
It is possible that the
measurements are not
correctly displayed.
Please contact Support.
-
-
SENTRON PAC4200
Manual, 09/2008, A5E02316180B-01