Electrical Connection - Parmco PPOV-9S-48 Installation And Operating Instructions Manual

Electrical Connection

Ovens equipped with a three-pole power supply cable are designed to operate with an alternating
current . The earth wire for the appliance is yellow-green in color.
Ensure that all connections are tight and secure
To install the cable, proceed as follows:
1. Remove the wire clamp screw and the three contact screws L-N-
2. Fasten the wires beneath the screw heads using the following color scheme: Blue (N) Brown (L)
Yellow-Green (E)
3. Fasten the supply cable in place with the clamp and close the cover of the terminal board .
Connecting the supply cable to the mains
When connecting the cable directly to the mains, install an omni-polar circuit breaker with a minimum -
contact opening of 3 mm between the appliance and the mains. The omni-polar circuit breaker should be
sized according to the load and should comply with all New Zealand standards and regulatory
requirements.
The supply cable should be positioned so that it cannot be in contact with any hot parts of this appliance.
Care should be taken that the cord is not folded or damaged during installation.
Before making the connection, check that:

The appliance is correctly earthed.

Terminal block connections are tight and secure.

The specifications indicated on the data plate correspond to those of the electrical mains system
of the home.

The electrical capacity of the system and sockets will support the maximum power of the
appliance, as indicated on the data label.

The plug and socket (if used) are easily accessible.
19