Table of Contents
Advertisement
Those ovens equipped with a three-pole power
supply cable are designed to operate with an
alternating current .The wire for earthling the
appliance is yellow-green in colour.
Fitting on a Power Supply Cable
Opening the terminal board:
Using a screwdriver, prize the bolt on the side tabs of the terminal board cover;
Using a screwdriver unhooking the no.2fixing hooks, pull open the cover of the terminal
board.
To install the cable, proceed as follows:
Remove the wire clamp screw and the three contact screws L-N -
Fasten the wires beneath the screw heads using the following colour scheme :Blue (N)
Brown (L) Yellow-Green
Fasten the supply cable in place with the clamp and close the cover of the terminal board.
Connecting the supply cable to the mains
Install a standardized plug corresponding to the load indicated on the data plate. When connecting
the cable directly to the mains, install an
omni polar circuit breaker with a minimum contact opening of 3 mm between the appliance and the
mains .The omni polar circuit breaker should be sized according to the load and should comply with
current regulations (the earth wire should not be interrupted by the circuit breaker).
The supply cable should be positioned so that it does not reach a temperature of more than 50℃ with
respect to the room temperature, anywhere along its length , or protected by insulation sleeping
having an appropriate rating.
Before making the connection, check that:
The electrical safety of this appliance can only be guaranteed if the cooker is correctly and
efficiently earthed, in compliance with regulations on electrical safety. Always ensure that
the earthling is efficient; if you have any doubts call in a qualified technician to check the
system .The manufacturer declines all responsibility for damage resulting from a system
which has not been earthed.
Before plugging the appliance into the mains, check that the specifications indicated on the
date plate (on the appliance and /or packaging) correspond to those of the electrical mains
system of your home.
Check that the electrical capacity of the system and sockets will support the maximum
power of the appliance, as indicated on the data plate .If you have any doubts, call in a
qualified technician.
If the socket and appliance plug are not compatible, have the socket replaced with a
suitable model by a qualified technician. The latter, in particular, will also have to ensure
that the cross sections of the socket cables are suitable for the power absorbed by the
appliance. The use of adapters, multiple sockets and /or extensions, is not recommended. If
their use cannot be avoided, remember to use only single or multiple adapters and
extensions which comply with current safety regulations .In these cases, never exceed the
maximum current capacity indicated on the single adapter or extension and the maximum
power indicated on the multiple adapter, the plug and socket must be easily accessible.
ELECTRICAL CONNECTION
23
Advertisement
Table of Contents
