Maintenance - Parmco PPOV-9S-48 Installation And Operating Instructions Manual

Before cleaning your oven or performing maintenance, disconnect the oven from the power supply.
To extend the life of your oven, it must be cleaned frequently, otherwise further baking and roasting will
cause the deposits to bake on even harder and cleaning may become difficult and in extreme cases
impossible.

For best results the oven should be cleaned soon after use when the oven is still warm using
warm soapy water

Wash all roasting trays and wire racks and other accessories frequently

Do not use scouring pads or cloths, steel wool, knives or other abrasive materials

Do not use abrasive or corrosive substances as this may damage the enamel

For tough stains use non caustic cleaners specifically recommended for ovens

After cleaning, rinse thoroughly and dry the oven.

Never use a steam cleaner for cleaning inside of the oven.
There is a rubber seal surrounding the oven opening which guarantees its optimum performance. Check
the condition of the seal on a regular basis. If necessary, clean the seal but avoid using abrasive products.
Should the seal become damaged, please contact Parmco Appliances. This may or may not be covered
under warranty.
We recommend you avoid using the oven until the seal has been replaced.
Never place anything (including foil and oven trays) on the bottom of the oven when it is in operation
as this will result in damage to the enamel.
Make sure the oven is cool before cleaning.
● Do not hand clean the door seal.
● Do not use coarse scouring pads or cleaning sponges.
● To avoid damaging the enamelled oven surfaces, use commercially available oven cleaners.
● To remove stubborn soil, use a special oven cleaner.
Oven door glass
The oven door is equipped with three sheets of glass placed against each other. The inner & middle
sheets can be removed for cleaning.

Do not use harsh abrasive cleaners or sharp metal scrapers to clean the oven door glass since
they can scratch the surface, which may result in the shattering of the glass.

Do not spray oven cleaner on the oven door glass as it may damage it.

The door becomes light when the glass is removed.

To remove the glass the oven door hinges must be set to the "locked" position. This will ensure
the door does not slam shut when the door glass is removed.

MAINTENANCE

15