Table of Contents
Advertisement
It is the law in New Zealand that this appliance must be installed by authorised
persons. The installation must comply with all the appropriate New Zealand
Standards and Regulatory Requirements with particular reference to the New
Zealand Electrical Standards.
Any attempt to install this or any other Parmco product without an authorised
person could result in damage to the product and a possible health hazard. Not
having an authorised person install this appliance may result in all associated
warranties from Parmco Appliances being null and void.
Connecting to the mains power supply
Electrical connections must be made as per the data label fixed to the rear of the oven by an
authorised person.
Where the appliance is not connected to the mains electricity supply by a plug, an Omni polar cutout
device (with a contacts gap of at least 3 mm) must be fitted on the supply side of the connection to
meet safety requirements.
When power is connected, the electronics of the oven are initialized. The electric cable must be long
enough for it to be connected to the built-in oven standing on the floor in front of its unit before it is
installed. This will ensure that the cable and connections are not stretched during installation.
Open the back cover of the terminal block at the bottom (using a flat-bladed screwdriver) and check
all connections are tight and secure.
The earth wire must be connected to the
Electrical Connection
IMPORTANT NOTE
terminal of the oven.
- 8 -
Advertisement
Table of Contents
