Getting Started; The Power Supply - Elcometer 331 SH Operating Instructions Manual

G
ETTING STARTED

3 GETTING STARTED

This section of the instructions is intended for first-time users of the Covermeter. It contains
essential information about batteries, assembling the Covermeter, the controls and the display. At
the end of this section you will be ready to take readings.

3.1 The power supply

Your Covermeter is powered by a rechargeable Lithium-Ion
inside or outside the Covermeter.
One battery pack is supplied with the Covermeter. To increase productivity on site, Elcometer
recommends that you purchase a spare battery pack which can be charged while you are using
your Covermeter. To order an additional battery pack (see "Accessories" on page 64), contact
Elcometer or your local Elcometer supplier.
Charging the batteries
The rechargeable battery must be fully charged before using the Covermeter for the first time. Use
only the charger supplied with your Covermeter to charge the battery. Use of any other type of
charger is a potential hazard, may damage your Covermeter and will invalidate the warranty. Do not
attempt to charge any other batteries with the supplied charger.
Always charge the battery indoors. To prevent overheating, ensure that the charger is not covered.
1. Referring to Figure 2, unscrew the retaining screw (1) and open the interface access cover (2)
on the rear of the Covermeter.
3
2. Connect the lead from the charger into the socket marked 'Charger Input' behind the interface
access cover (Figure 3).
b. The Covermeter is not designed to operate using dry cell batteries.
4
R
Figure 2. Covermeter rear panel
b
battery pack which can be charged
3
1
2