Sony DVS-9000 System User Manual page 1057

Icon Title Message
GPI Please set Target.
Output
Please set Trigger Type.
Please set Reg No.
Please set Aux Bus No.
Please set Src No.
Please set Pulse Width.
Please set Pulse Timing.
HDD Failure.
Format HDD device is busy.
In order to complete HDD
format, System needs to be
restarted and formatted again.
System will be restarted, then
please execute HDD format
again.
HDD Success!!
Format System will be restarted.
Initial Initializing now...
Read
Install No Task.
Select a package on the list.
Install Some files are skipped.
Not Found.
The software package does not
exist on the removable disk.
Description
7325.3/4: Engineering Setup >Panel >Device
Interface >GPI Output
7337.2/3: Engineering Setup >Switcher
>Device Interface >GPI Output
7337.4/5: Engineering Setup >Switcher
>Device Interface >GPI Output
7344.3/4: Engineering Setup >DME >Device
Interface >DME1 GPI Output
7344.7/8: Engineering Setup >DME >Device
Interface >DME2 GPI Output
7354/7354.1: Engineering Setup >DCU >GPI
Output Assign
In the above menus, when making a setting, a
parameter setting value was incorrect. Check
the settings, and try again.
7317: Engineering Setup >System
>Maintenance
In the above menu, the hard disk formatting
procedure failed.
If the hard disk is functioning correctly, or in
some cases when there is damage to the disk,
it may not be possible to format the disk
correctly in a single attempt. In such cases, it is
necessary to restart the system, and then carry
out formatting again.
Press [OK] to restart the system.
7317: Engineering Setup >System
>Maintenance
In the above menu, the hard disk formatting
procedure completed successfully.
Press [OK] to restart the system.
This popup message appears during menu
startup, while system information is being read
in.
7316.10: Engineering Setup >System >Install/
Unit Config >Install
In the above menu, the package for installation
was not selected. Select a package to be
installed.
7316.10: Engineering Setup >System >Install/
Unit Config >Install
In the above menu, some program files were
not installed, for example because the
hardware is not present. Check the skipped
files against the hardware configuration, to
confirm that the installation was completed
correctly.
7316.10: Engineering Setup >System >Install/
Unit Config >Install
In the above menu, the software package to be
installed was not found. Check that the memory
card is correctly inserted, and try the installation
once more.
1057
Error Messages