DICENTIS
6.4.4
Audio settings
–
–
–
–
–
–
Bosch Security Systems B.V.
Audio tones: Use the Set and Remove buttons to upload and remove custom chimes for
Summon and Priority.
Audio file specification:
–
PCM format.
–
16 bits per sample.
–
48 k sample rate.
–
Mono.
–
Max 700 kb file size.
Audio tones audible on headphones: When selected, the audio tones are sent to the
headphones of the participants and interpreters. Off by default.
Mic: Shows the signal of the microphones when they are being spoken in.
System:
–
Master volume: Master volume to control the devices' loudspeakers and the sound
reinforcement output.
–
LSP: Sets the volume for the device loudspeakers in decibel (dB).
–
SR: Sets the volume for the sound reinforcement output.
–
Change EQ: Sets the equalizer for both the device's loudspeaker and the sound
reinforcement output.
Line Input / Output:
–
In 1: Sets the sensitivity of Line input 1.
–
Out 1: Sets the sensitivity of Line output 1.
–
Ambient: Sets the ambient audio On or Off for Line input 1:
On (default setting): Audio connected to In 1 is only routed to the delegate
headphones and the recorder output when no microphone is active.
Off: Audio connected to In 1 is always routed to the delegate loudspeakers, delegate
headphones, and the PA output.
–
In 2: Sets the sensitivity of Line input 2.
–
Out 2: Sets the sensitivity of Line output 2.
–
In 2 / Out 2 mode selection menu: Defines the mode of Line input 2 and Line output
2. Click the arrow on the drop-down list to choose between:
LSP: When selected, allows the audio from the delegate's loudspeaker to be
amplified by an external system.
Recorder (Int. floor): When selected, allows the audio to be recorded.
Mix-minus: When selected, prevents acoustic feedback when two systems are
connected for example via telephone coupler.
Insertion: When selected, allows an external system to process/equalize the audio.
Unprocessed: When selected, receives/sends the unprocessed audio from In 2 / Out
2.
–
For more information, see Audio routing settings.
Dante Input / Output:
–
In 1: Sets the sensitivity of Dante
–
Out 1: Sets the sensitivity of Dante
–
Ambient: Sets the ambient audio ON or OFF for Dante
ON (default setting): Audio connected to In 1 is only routed to the delegate
headphones and the recorder output when no microphone is active.
OFF: Audio connected to In 1 is always routed to the delegate loudspeakers,
delegate headphones, and the PA output.
–
In 2: Sets the sensitivity of Dante
TM
/ OMNEO input 1.
TM
/ OMNEO output 1.
TM
/ OMNEO input 2.
Software Manual
Meeting application | en
TM
/ OMNEO input 1:
2017.02 | V1.9 |
55