Bosch DICENTIS Software Manual page 18

18 en | System Overview
–
–
Routers
The following minimal requirements apply to routers:
–
–
–
–
–
–
2017.02 | V1.9 |
(Rapid) Spanning tree needs to be DISABLED for optimal operation. When enabled, it can
cause slow connections to the switch. In case of a redundant network where you would
require RSTP, configure the switch to use the "portfast" mode.
(Optional) SNMPv3 support for switch supervision purposes.
1 Gbit or higher Ethernet ports.
Supports PIM‑DM or Bidirectional PIM.
Performs IP routing in hardware (i.e. a 'layer 3 switch') to minimize the routing delay.
Packet forwarding rate > 1,000,000 packets per second per port (e.g. 8 Mpps for an
8‑port router).
Non-blocking backplane per switching port, i.e. 2 Gbit per port (e.g. 16 Gbps for an
8‑port router).
MAC address table of at least 1000 addresses per directly connected subnet.
Software Manual
DICENTIS
Bosch Security Systems B.V.