Xerox 6030 User Manual page 98

PORT SETTING
TCP/IP
TCP/IP
Default Parser
Default Parser
HPGL
IP Address
100. 000. 000. 000
IP Address
120. 000. 000. 000
IP Address
123. 123. 123. 001
70
Downloaded From ManualsPrinter.com Manuals
1
Display [TCP/IP] on the selection screen,
and then press the <
2
Select the item that is to be set up with the
use of the < > and < > keys, and then
press the <
[Ethernet Setting], [Default Parser], [IP
Address], [Mask Value], [E-Net Address],
[Dynamic Routing], and [Static Routing] will
be displayed in that order.
3
Select the parameters with the use of the
*
< > and < > keys, and then press the
<Set> key.
An asterisk [*] will be displayed on the right
side of the parameters once they have been
set.
Entering addresses
1. Move the cursor to the left and right with
the use of the <
2. Select the required value with the use of
the < > and < > keys. The value will
increase or decrease sequentially
between 0 and 9.
*
3. Press the <Set> key once all values have
been entered.
> key.
> key.
• Additions can be made to the
routing table when [Static Routing]
is enabled.
• The [E-Net Address] can only be
displayed, not changed.
> and < > keys.
• To proceed to the next menu, move
the cursor to the right-hand side
and press the < > key.
• To return to the previous menu,
move the cursor to the left-hand
side and press the < > key.
Chapter 3 Printer Setup