Taking Out Of Service; Preservation For Temporary Taking Out Of Service; During Immobilization; After The Machine Had Been Taken Out Of Service - Terex TL80 Operating Instructions Manual

7 Maintenance and Care

7.10 Taking out of service

7.10.1 Preservation for temporary taking out of
service
In order to prevent damage (corrosion, etc.) from
storage during shutdown periods over three
months, certain preservation measures must be
taken:
•
We recommend keeping the machine in a dry,
dust-free room during the storage period.
•
Thoroughly clean the inside and outside of the
machine, including the engine.
•
Lubricate the machine according to the
lubrication plan.
•
Check the oil levels of all assemblies such as
axles, transmission(s), etc. and top up if
necessary.
•
Check the hydraulic oil level and top up if
necessary.
•
Repair any paint damage.
•
Fill the diesel tank completely, to prevent
corrosion of the tank walls.
•
Check the antifreeze level in the coolant and
adjust if necessary.
•
Perform all preservation measures specified in
the diesel engine Operating Manual.
•
Check the tire pressure according to the
prescribed value and protect the tires from
direct sunlight.
•
Treat bare piston rods with a commercially
available anti-corrosion agent.
•
Remove and clean the battery and keep it
according to regulations in a dry - in winter,
frost-proof - room. Coat connections with a little
pole grease.
•
Seal off the air intake opening of the air filter
system and the exhaust pipe opening.

7.10.2 During immobilization

When the machine is out of use for 6 months, after
this time all assemblies must be brought to
operating temperature
approx. 15 min.
•
Beforehand, the anti-corrosion coat must be
removed from the piston rods, and the
openings of the air filter system and the
exhaust pipe freed.
•
After the maneuvering cycle, preserve the
machine once more as previously described.
96
and maneuvered for
7.10.3 After the machine had been taken out of
service
Before putting the machine into operation once
more, the following measures must be carried out:
•
Anti-corrosion coat must be cleaned from the
piston rods.
•
Seal off the air intake opening of the air filter
and the exhaust pipe opening.
•
Remove the air filter insert, check its condition
and replace if necessary.
•
Clean the machine with a neutral detergent.
•
Check and, where required, re-charge and re-
install the battery
•
Carry out all measures for putting the diesel
engine back into operation listed in the Engine
Operating Manual.
•
If the machine has been out of use for more
than 6 months, the oil in the assemblies such
as axles, transmission(s),
changed.
•
If hydraulic oil filters such as suction and return
filters as well as breathers have been out of
use for more than 6 months, they must be
replaced.
•
Lubricate the machine according to the
lubrication plan.

7.10.4 Disposing of the wheeled loader

Warning
Damage to persons and property
If the wheeled loader is not disposed of
by qualified personnel at the end of its
service life, this may result in accidents
and environmental damage.
The wheeled loader can only be
disposed of by an appropriate waste
disposal company.
Terex recommends
machine to a Terex dealer.
etc. must be
returning the
TL80