Wheels - Terex TL80 Operating Instructions Manual

7.9.13.3 Wheel hub
Checking the axle oil level
•
Remove the inspection plug (57/1) check and
top up oil if required.
Changing axle oil
The wheel
inspection, filling and drain plug!
•
Turn the wheel until the screw plug (57/1) on
the hub is at the bottom.
•
Open the screw plug and catch the escaping
oil.
•
Flush out if necessary.
•
Turn the wheel to the filling and inspection
position; the inspection
horizontal.
•
Fill in oil up to the lower edge of the hole.
•
Carefully close the screw plug.

7.9.14 Wheels

Checking the tire pressure
•
Check the air pressure in accordance with the
pressure chart given in chapter 3.8.
Checking the tightness of wheel nuts
•
During the first 50 operating hours, check the
tightness of the wheel nuts (M 20x1,5) daily
and subsequently every week, and tighten to
the correct torque if necessary.
Fastening torque: 460 Nm
• When fitting a wheel, tighten the nuts to the
correct torque crosswise in several stages.
TL80
hub has a combined
mark must
1
Ablaßstellung/Drain
be
Fig. 57 Wheel hub
Maintenance and Care 7
Ölstand
Level
L834-057
93