Panasonic KX-TVM50 Programming Manual page 119

Note
• The number of "K" signals assigned for a sequence of Input digits must be the same as the
number entered in the sequence of Output digits.
Value Range
Max. 20 digits consisting of 0–9,
S: Skip (ignore) the code.
K: Keep the code as it is.
Dialling Parameters
Number of Digits to Access Outside Line
This parameter should match the number of digits of the Line Access Code required by the PBX when
making outside calls.
Example:
If the PBX requires callers to dial "9" to access a Trunk, this parameter should be set as "1". This
enables the VPS to recognise that an outgoing call setup sequence is completed once the initial "9"
has been dialled (9-123-4567).
Value Range
0–8 digits
Call Transfer No Answer Time
Specifies the length of time that the VPS waits before retrieving the transferred call when there is no
answer at the destination extension.
Note
• Make sure that the duration of Call Transfer No Answer Time is longer than the duration of
Call Forwarding No Answer Time at the PBX. Otherwise, the PBX may forward the call
immediately to the extension's Intercept Routing destination according to PBX
programming, rather than return the call to the VPS.
Value Range
10 s–60 s
Outgoing Call No Answer Time
Specifies the length of time that the VPS waits before concluding that there is no answer at the
outside number called.
Value Range
10 s–90 s
Pause Time for ","
Specifies the pause time for "," used in call sequences.
, #, A–D, S (Input digit only), and K
2.5 System Parameters
Programming Manual 119