Hardware (H/W) Settings; Global Parameters - Panasonic KX-TVM50 Programming Manual

2.6 Hardware (H/W) Settings

2.6 Hardware (H/W) Settings
Hardware settings are divided into the following categories:
–

Global Parameters

– Port Parameters
2.6.1 Global Parameters
Global parameters define the settings that affect integration with the PBX.
Flash Time
For Inband and No Integration only. Specifies the length of time the hook switch must be pressed
before the PBX will recognise it as a flash hook signal. The settings made here should match the
settings of the PBX.
Value Range
100 ms, 300 ms, 600 ms, and 900 ms
CPC Signal
For Inband and No Integration only. Specifies the minimum time necessary to detect an interruption
in the CPC (Calling Party Control) signal received from the PBX. The VPS is able to determine that
the line has been disconnected when it detects an interruption of the CPC signal. The settings made
here should match the settings of the PBX.
Value Range
None, 6.5 ms, 150 ms, 300 ms, 450 ms, 600 ms, and 900 ms
Disconnect Time
Specifies the length of time the line will be unavailable after a call has ended.
Value Range
1 s–8 s
Delay After Dialling Before Analysis
Specifies the length of time between the end of call and the start of "Call Progress Tone" detection
when an outgoing call is dialled.
Value Range
0 ms–20000 ms, units 100 ms
Maximum Time to Wait for Dial Tone
Specifies the length of time that the VPS waits for dial tone detection.
138 Programming Manual