List Of Snmp Traps - Hirschmann RS20 User Manual

Operation Diagnosis
9.1.1

List of SNMP Traps

All the possible traps that the device can send are listed in the following table.
Trap name
authenticationFailure
coldStart
hmAutoconfigAdapterTrap is sent when AutoConfiguration AdapterACA is removed or
linkDown
linkUp
hmTemperature
hmPowerSupply
hmSigConRelayChange
newRoot
topologyChange
risingAlarm
fallingAlarm
hmPortSecurityTrap
hmModuleMapChange
hmBPDUGuardTrap
hmMrpReconfig
hmRingRedReconfig
hmRingRedCplReconfig
hmSNTPTrap
hmRelayDuplicateTrap
lldpRemTablesChangeTra
p
hmConfigurationSavedTra
p
hmConfigurationChangedT
rap
Table 22: Possible traps
Basic Configuration
Release 6.0 07/2010
Meaning
is sent if a station attempts to access the agent without permission.
is sent for both cold and warm starts during the boot process after
successful management initialization.
plugged in.
is sent if the link to a port is interrupted.
is sent as soon as the link to a port is re-established.
is sent if the temperature exceeds the set threshold values.
is sent if the status of the voltage supply changes.
is sent if the status of the signal contact changes during the
operation monitoring.
is sent if the sending agent becomes the new root of the spanning
tree.
is sent if the transmission mode of a port changes.
is sent if an RMON alarm input exceeds the upper threshold.
is sent if an RMON alarm input falls below the lower threshold.
is sent if a MAC/IP address is detected at the port which does not
correspond to the current settings of:
– hmPortSecPermission and
– hmPorSecAction is set to either trapOnly (2) or portDisable (3).
is sent if the hardware configuration is changed.
is sent if a BPDU is received at a port when the BPDU Guard
function is active.
is sent if the configuration of the MRP-Ring changes.
is sent if the configuration of the HIPER-Ring changes.
is sent if the configuration of the redundant ring/network coupling
changes.
is sent if errors occur in connection with the SNTP (e.g. server
cannot be reached).
is sent if a duplicate IP address is detected in connection with
DHCP Option 82.
is sent if an entry in the topology remote table is changed.
is sent after the device has successfully saved its configuration
locally.
is sent when you change the configuration of the device for the first
time after it has been saved locally.
9.1 Sending Traps
177