Device Status; Configuring Traps - Hirschmann RS20 Reference Manual

Diagnosis

7.6.3 Device status

Select the tab page "Alarm 1" or "Alarm 2" (for devices with two signal
contacts).
In the "Mode Signal Contact" field, you select the "Device status" mode.
In this mode, the signal contact is used to monitor the status of the device
(see on page
possible.
The device status "Error"
means of a break in the contact via the potential-free signal contact (relay
contact, closed circuit).

7.6.4 Configuring traps

Select generate Trap, if the device is to create a trap as soon as the
position of a signal contact changes when function monitoring is active.
Figure 33: Signal contact dialog
86
82 „Device Status")
(see on page
and thereby makes remote diagnosis
82 „Device Status")
7.6 Signal contact
is reported by
RM Web L2B
Release 5.0 04/09