Hirschmann RS20 User Manual page 213

Operation Diagnosis
"SNMP Logging" frame:
Activate "Log SNMP Get Request" if you want to send reading
SNMP requests to the device as events to the syslog server.
Select the level to report at which the device creates the events from
reading SNMP requests.
Activate "Log SNMP Set Request" if you want to send writing SNMP
requests to the device as events to the syslog server.
Select the level to report at which the device creates the events from
writing SNMP requests.
Note: For more details on setting the SNMP logging, see the "Syslog"
chapter in the "Web-based Interface" reference manual.
enable
configure
logging host 10.0.1.159 514 3 Select the recipient of the log messages and its
logging syslog
exit
show logging hosts
Index IP Address
----- -----------------
1 10.0.1.159
enable
configure
logging snmp-requests get
operation enable
logging snmp-requests get
severity 5
logging snmp-requests set
operation enable
logging snmp-requests set
severity 5
exit
show logging snmp-requests
Basic Configuration
Release 6.0 07/2010
Switch to the Privileged EXEC mode.
Switch to the Configuration mode.
port 514. The "3" indicates the seriousness of the
message sent by the device. "3" means "error".
Enable the Syslog function.
Switch to the privileged EXEC mode.
Display the syslog host settings.
Severity Port
---------- ----
error 514
Switch to the Privileged EXEC mode.
Switch to the Configuration mode.
Create log events from reading SNMP requests.
The "5" indicates the seriousness of the message
that the device allocates to messages from
reading SNMP requests. "5" means "note".
Create log events from writing SNMP requests.
The "5" indicates the seriousness of the message
that the device allocates to messages from
writing SNMP requests. "5" means "note".
Switch to the privileged EXEC mode.
Display the SNMP logging settings.
9.13 Syslog
Status
-------------
Active
213