Honeywell OMNI 408 Installation And Setup Manual page 79

To alter the value in any location, enter the desired digit from the program sheet, then press the [#]
key to advance to the next location, or if no further changes need to be made, press [Stay] to exit
programming.
NOTE: If an entry error was made and the [#] key was not yet pressed, re-enter the desired entry, then
press the [#] key to advance to the next program location or press [Stay] to exit programming.
Pressing the respective key on the keypad can perform numeric entries 0-9. Entries of A-F require 2
keystrokes, as follows:
Press the [Code] key followed by 1-6 keys for values A-F.
VALUE
A
B
C
Example: To enter an A, press the [Code] key followed by the [1] key.
The keypad chirps on each keystroke (unless the keypad sounder has been turned off). In addition, a
beep confirms advancement between question numbers.
Four beeps signify an invalid input entry (unless the keypad sounder has been turned off). After you
make an invalid entry, the system positions you at the same question number and location as
immediately before you made the invalid entry.
Exit System Program Mode
After all programming has been completed, press the [Stay] key to exit the system Program mode.
Data Entry
KEYSTROKES VALUE
[Code] [1]
[Code] [2]
[Code] [3]
Question Acknowledgment
Section 9 - Data Entry Via Keypads
KEYSTROKES
D [Code] [4]
E [Code] [5]
F [Code] [6]
9–7