Honeywell OMNI 408 Installation And Setup Manual page 34

OMNI-408/OMNI-408EU Installation and Setup Guide
QUESTION 00
INSTALLER CODE
NOTE: When Installer Programming is entered, the system automatically displays Question 01. To
display this question for review and/or modification of the Installer Code, enter [✱] + [0] + [0].
Enter the 4-digit Installer Code in Question 00, Locations L1–L4.
QUESTION 01
PRIMARY TELEPHONE NUMBER
Enter the telephone number (including area code and/or dialing prefix, if necessary) of the primary
central station receiver in L1 - L16. Enter the valid digits from the table below.
Digit FUNCTION
0-9 0-9
A Signifies end of the phone
number
B Asterisk (✴)
C 3-Second pause
D Pound (#)
✴70C (TouchTone) 1170C
E
(Rotary)
F 800
QUESTION 02
SECONDARY TELEPHONE NUMBER
Using the table in Question 01 to determine valid digits, enter the telephone number (including area
code and/or dialing prefix, if necessary) of the secondary central station receiver in L1 - L16.
The secondary telephone number is used if the panel is unable to reach the central station via the
primary number. This is known as BACKUP reporting. If the SPLIT REPORTING feature is
programmed, then opening and closing signals are directed to the secondary CS phone number only,
while all other conditions are reported to the primary number.
QUESTION 03
CALLBACK TELEPHONE NUMBER
Using the table in Question 01 to determine valid digits, enter the telephone number (including area
code and/or dialing prefix, if necessary) for this control panel to reach the callback location. The
callback number is the optional location of the Compass Downloader where the control panel calls
during a remote communications (upload/download, etc.) session. During remote communications, the
programming device and the control panel will first confirm the CS security code. If it is valid,
communications can begin. If you have programmed a callback number, the control panel hangs up and
dials the callback number.
NOTE: If you do not want callback capability, enter AAAAAAAAAAAAAAAA.
7–2
DEFAULT = 234AAAAAAAAAAAAA
COMMENTS
Dialing digits
Enter after last digit of phone
number
Enter whenever the asterisk is
used
Provides delay to wait for dial tone
Enter whenever the pound is used
Enter to disable Call Waiting
Enter whenever the "800" prefix is
needed
DEFAULT = AAAAAAAAAAAAAAAA
DEFAULT = AAAAAAAAAAAAAAAA
DEFAULT = 2468
REPORTING ROUTE:
The system reports all signals
to the primary receiver phone
number. If the secondary
phone number has been
programmed, the panel
alternates between the
primary and secondary
receivers for a maximum of 8
attempts each until the signal
has been acknowledged.