Honeywell OMNI 408 Installation And Setup Manual page 26

OMNI-408/OMNI-408EU Installation and Setup Guide
Quick Arming [#] [1]
If programmed (see Programming Question 07, Location 3), Quick Arming allows arming of the system
without entry of a user code, and reports as User No. 8 to the central station if a 2-digit transmission
format is defined.
NOTE: The system must be in Ready mode. A user code is required to disarm the system.
Quick Force Arming [#] [2]
If programmed (see Programming Question 07, Location 3), Quick Force Arming allows arming of the
system without entry of a user code and bypasses any zones that are not ready. It reports as User No.
8 to the central station if a 2-digit transmission format is defined.
NOTE: To disarm, the user code is required.
Set Time/Date [#] [3]
The AC-based clock can be set at the keypad, but it can only be viewed by the PC downloader software
or an LCD keypad.
To set time/date: Press [#] [3] Hours, Minutes, Month, Day, Year
Where:
Hours = 2 digits (00-23)
Minutes = 2 digits (00-59)
Display Zone Directory (LCD Keypad Only) [#] [4]
Pressing [#] [4] will scroll through the zone number and zone descriptors on the LCD keypad. The
keypad will display the following:
The system will exit this mode either automatically (no keys pressed) or when the star (*) key is
pressed.
Toggle Chime [#] [6]
This quick command is always enabled. If any zones are programmed with a Chime option (see
Programming Questions 11–18), then [#] [6] will turn the system chime on or off, depending on its
original state.
• The Toggle Chime command toggles the Chime feature for the entire system. Because
there are no visual indications on the keypads after toggling the chime, you must be aware
of its present state.
• The installer must enable the Chime option for any zone that requires a chime.
5–2
Month = 2 digits (01-12)
Day = 2 digits (01-31)
DIRECTORY ZN #
ZONE DESCRIPTOR
Year = 2 digits (00-99)